Nice, thanks.
Thanks Eric.
This used to work fine in 2012 but does not in 2013. It might depend on something else in the code since doing this with the Parameter Editor works as…
Yes, better in 2012.
actually for o in selection where iskindof o SplineShape do weldSpline o 0.1 welds the vertices but leaves the splines open (it does not weld the fi…
I found the solution here: for o in selection where iskindof o SplineShape do weldSpline o 0.1 Sorry for the redundant post.
Thanks Raytracer05, There’s a lot that I need to learn.
For the clear explanation.
thank you. curious that the cursor goes back at the beginning of the string at enter… differently than the typical behavior of fields. I also don’t u…
@Raytracer05 yes, sorry for the confusion, you are absolutely right. the code is not needed. @denisT sorry I can’t understand the workaround you are …
Hey Raytracer05, when I remove the lines values do not hold again… :hmm:
what should I be using at: … on manu entered i do … to have the CA stored when pressing the enter key at the end of the string instead of individual …